Input Shaft Disassemble

Input Shaft Disassemble

Tools Required

^ J 22912-B Split Plate Bearing Puller





1. Install the J 22912-B (1) under the input shaft bearing.
2. Remove input shaft bearing cone using the J 22912-B (1) and a hydraulic press.





3. Important:
^ The input shaft bearing race is not serviceable. If the race is faulty, replace the input shaft bearing retainer.
^ Replace both the input shaft bearing and the input shaft bearing retainer, if either is faulty.

Remove the seal from the input shaft bearing retainer.
4. Discard the seal.