Interior - Passenger Seat Back Rattling
Bulletin No.: 07-08-59-006Date: July 10, 2007
TECHNICAL
Subject:
Passenger Front Seat Back Rattle Noise When Lumbar is Fully Recessed (Secure Passenger Front Seat Left and Right Lumbar Wiring Harnesses to Rear Seat Back Cushion Actuators)
Models:
2008 Buick Enclave
2007-2008 GMC Acadia
2007-2008 Saturn OUTLOOK
with Control Power Lumbar Passenger Seat (RPO AT9)
Condition
Some customers may comment on a rattling noise coming from the passenger front seat back. This condition may occur when the lumbar support is fully recessed.
Cause
The cause of the rattle may be the left and/or right lumbar wiring harness contacting the inner passenger seat back finish panel.
Correction
Secure the passenger front seat left and right lumbar wiring harnesses to the rear seat back cushion actuators using the steps below.
Verify that the rattle is coming from the passenger front seat back.
Remove the passenger front seat back finish panel.
Tip
Use a flashlight to help pinpoint the top two retainers.
Using a flat-bladed tool, start from the side of the seat back finish panel and push inward on the top two retainers while pulling back on the top of the finish panel.
Release the two bottom plastic hooks by lifting the rear finish panel upward to remove from the seat. Locate the left lumbar wiring harness and position the wiring harness towards the seat back cushion.
Install a tie strap (1) around the left lumbar wiring harness and actuator. Then tighten the tie strap (1) and cut off any excess nylon strap.
Locate the right lumbar wiring harness and position the wiring harness towards the seat back cushion.
Install a tie strap (1) around the right lumber wiring harness and actuator. Then tighten the tie strap (1) and cut off any excess nylon strap.
Install the passenger front seat back finish panel by attaching the bottom plastic hooks first, then seat the top two retainers.
Verify that the condition is fixed.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer