Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust

Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust

Removal Procedure




1. Remove the engine mount strut bracket.
2. Disconnect the engine wiring harness electrical connector (3) from the bank 2 exhaust camshaft position (CMP) sensor (4).




3. Remove the CMP sensor bolt and sensor (4).

Installation Procedure






Notice: Refer to Fastener Notice.

1. Install the CMP sensor (4) and bolt.

Tighten the bolt to 10 N.m (89 lb in).




2. Connect the engine wiring harness electrical connector (3) to the bank 2 exhaust CMP sensor (4).
3. Install the engine mount strut bracket.