Accelerator Pedal Position Sensor: Service and Repair

Accelerator Pedal Position Sensor Replacement

Removal Procedure




1. Remove the left instrument panel insulator.
2. Remove the steering column opening filler.
3. Remove the instrument panel wiring harness electrical connector (2) from the accelerator pedal position (APP) sensor assembly.






Important: Due to clearance issues, the upper attachment bolt cannot be removed from the APP sensor assembly. Loosen the bolt completely and leave the bolt in the component until the assembly is removed from the vehicle.

4. Remove the APP sensor bolts and sensor assembly from the vehicle.

Installation Procedure




1. Install the upper bolt into the APP sensor assembly.
2. Install the APP sensor assembly into the vehicle.

Notice: Refer to Fastener Notice.

3. Install the remaining 2 lower APP sensor assembly bolts.

Tighten the bolts to 8 N.m (71 lb in).




4. Install the instrument panel wiring harness electrical connector (2) to the APP sensor assembly.
5. Install the steering column opening filler.
6. Install the left instrument panel insulator.