B2745

DTC B2745

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptor
DTC B2745 00
- Traction Control Switch Circuit

Diagnostic Fault Information





Circuit/System Description

The driver may disable the Traction Control System (TCS) by pressing the traction control switch. The body control module (BCM) supplies a 12-volt signal on the traction control signal circuit. When the traction control switch is pressed, this voltage signal is grounded.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The BCM detects low voltage on the traction control signal circuit for 60 seconds.

Action Taken When the DTC Sets

* The BCM sends a serial data message to the electronic brake control module (EBCM) informing the EBCM that the desired TCS state cannot be determined.
* The EBCM defaults the TCS status to enabled.

Conditions for Clearing the DTC

The DTC clears automatically from Current status when the fault is corrected. Use a scan tool to clear the DTC from history status.

Diagnostic Aids

An intermittent short to ground on the traction control signal circuit is the most likely cause of a history DTC when no problem is found. When the Conditions for Setting this DTC are present, the driver is not able to disable traction control.

Reference Information
Schematic Reference

Antilock Brake System Schematics ([1][2]Antilock Brakes / Traction Control Systems)
Connector End View Reference

Component Connector End Views (Connector Views)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning)

Circuit/System Verification

Traction control can be disabled/enabled when the traction control switch is pressed and released.

Circuit/System Testing

1. Turn OFF the ignition for 5 seconds, then turn ON the ignition and wait at least 60 seconds.

• If DTC B2745 does not reset, go to Diagnostic Aids

2. Turn the ignition OFF. Disconnect the traction control switch harness connector. Turn the ignition ON and wait at least 60 seconds.

• If DTC B2745 does not reset, replace the traction control switch.
• If the DTC B2745 resets, check the TCS switch signal circuit for a short to ground or replace the BCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for EBCM/BPMV replacement, setup, and programming