Underhood Electrical Center or Junction Block Replacement

Underhood Electrical Center or Junction Block Replacement

Removal Procedure




1. Disconnect the negative battery cable.
2. Press tabs (1) inward and lift to remove the junction block cover.




3. Pull upward on the fuse relay center cover (1) to release the retaining tabs and remove the cover.
4. Note the location and remove the harness end bolts (2) and remove the harness ends from the fuse relay center.
5. Remove the fuse relay center bolts (3) and remove the fuse relay center from the junction block bracket.
6. Pull downward on the wiring harness ends to remove from the bottom of the fuse relay center.




7. Remove the junction block bracket retaining bolts (1) and remove the junction block bracket from the vehicle.

Installation Procedure






Notice: Refer to Fastener Notice.

1. Position the junction block bracket and install the bolts (1).

Tighten the junction block bracket bolts to 6 N.m (53 lb in).

2. Align the wiring harnesses and install the fuse relay center.




3. Install the fuse relay center bolts (3).

Tighten the relay center bolts to 6 N.m (53 lb in).

4. Install the harness end bolts (2).
5. Install the fuse relay center cover (1) over the relay center bolts. Press downward to engage the tabs.
6. Install the junction block cover. Press downward to engage the tabs.