Upper Control Arm Ball Joint Replacement

Upper Control Arm Ball Joint Replacement


Tools Required
* J 9519-E Lower Ball Joint Remover and Installer
* J 21474-01 Control Arm Bushing Set
* J 45117 Ball Joint Installation Spacer



Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
3. Remove the steering knuckle with wheel hub attached. Refer to Steering Knuckle Replacement (4WD) () .
4. Remove the upper ball joint retaining clip.




5. Remove the upper ball joint boot.
6. Remove the upper ball joint from the steering knuckle using J 9519-E .



Installation Procedure





1. Install the upper ball joint to steering knuckle using J 9519-E , J 21474-01 , and J 45117 .




2. Install the upper ball joint retaining clip.
3. Install the steering knuckle with wheel hub attached. Refer to Steering Knuckle Replacement (4WD) () .
4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
5. Lower the vehicle.
6. Check the front wheel alignment. Refer to Wheel Alignment Specifications (Specifications) .