Crankshaft Position Sensor Replacement

Crankshaft Position Sensor Replacement

Removal Procedure




1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the engine wiring harness electrical connector (4) from the crankshaft position (CKP) sensor (3).




3. Remove the CKP sensor bolt and sensor.

Installation Procedure

Important: When installing the CKP sensor, make sure the sensor is fully seated before tightening the bolt. A poorly seated CKP sensor may perform erratically and may set false diagnostic trouble codes (DTCs).






Important: Do not reuse the original O-ring seal.

1. If reinstalling the old CKP sensor, install a NEW O-ring seal onto the sensor.
2. Lubricate the O-ring seal with clean engine oil.

Notice: Refer to Fastener Notice.

3. Install the CKP sensor and bolt.

Tighten the bolt to 10 N.m (89 lb in).




4. Connect the engine wiring harness electrical connector (4) to the CKP sensor (3).
5. Lower the vehicle.
6. Perform the crankshaft position system variation learn procedure. Service and Repair