Steering Gear Pitman Shaft Seal Replacement (Non Rack and Pinion)
Steering Gear Pitman Shaft Seal Replacement (Non Rack and Pinion)
Tools Required
* J 4245 Internal Snap Ring Pliers
* J 6278 Pitman Shaft Bearing Remover and Installer
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Mark the position of the pitman arm to the pitman shaft.
3. Remove the Pitman Arm. Refer to Pitman Arm Replacement (Service and Repair) .
4. Drain the power steering fluid from the system.
5. Remove the pitman shaft and side cover. Refer to Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle (Service and Repair) .
6. Clean the exposed end of the pitman shaft.
7. Clean the steering gear housing.
8. Use a wire brush to clean the pitman shaft splines.
9. Remove the dust seal (1).
10. Remove the retaining ring using J 4245 .
Important: Use care not to score the power steering gear housing bore when prying out the seals and the washers.
11. Use a screwdriver to pry the backup washer (3) and the double lip seal (2) from the power steering gear housing (1).
12. Inspect the power steering gear housing (1) for burrs.
13. Remove the power steering gear housing (1) if necessary.
14. Insert the J 6278 through the hole in the top of the power steering gear housing (1).
15. Drive out the needle bearing (2).
Installation Procedure
1. Coat the double lip seal (2) and the washer (3) with grease.
2. Install the needle bearing (2) to the power steering gear housing (1) using J 6278 .
3. Install the double lip seal (2).
4. Install the backup washer (3).
5. Install the retaining ring using the J 4245 .
6. Install the pitman shaft and the side cover. Refer to Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle (Service and Repair) .
7. Install the dust seal (1).
8. Install the Pitman Arm. Refer to Pitman Arm Replacement (Service and Repair) .
9. Bleed the power steering system. Refer to Power Steering System Bleeding (Service and Repair) .
10. Lower the vehicle.