Power Brake Booster Outlet Hose Replacement

Power Brake Booster Outlet Hose Replacement

Removal Procedure






Notice: Refer to Power Steering Hose Disconnected Notice .

1. Install a drain pan under the vehicle.
2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .




4. Through the wheel well, disconnect the power brake booster outlet hose (1) from the power steering gear (2).
5. Lower the vehicle.
6. Remove the water deflector from the fender.
7. Remove the power brake booster outlet hose (1) from the power brake booster (2).
8. Remove the power brake booster outlet hose from the vehicle.



Installation Procedure


Notice: Refer to Installing Hoses Without Twists or Bends Notice .

1. Route the hose in the same position the hose occupied prior to removal.

Notice: Refer to Fastener Notice .





2. Install the power brake booster outlet hose (1) to the power brake booster (2). Hand tighten.
3. Raise the vehicle.




4. Through the wheel well, connect the power brake booster outlet hose to the power steering gear (2).

Tighten the hose fitting to 33 N.m (24 lb ft).

5. Lower the vehicle.
6. Tighten the power brake booster outlet hose at the power brake booster.

Tighten the hose fitting to 33 N.m (24 lb ft).

7. Install the water deflector to the fender.
8. Bleed the power steering system. Refer to Power Steering System Bleeding (Service and Repair) .
9. Remove the drain pan from under the vehicle.