Intake Air Temperature (IAT) Sensor 2 Replacement

Intake Air Temperature (IAT) Sensor 2 Replacement

Removal Procedure

1. Disconnect the negative battery cable.
2. Remove the air intake pipe.
3. Disconnect the intake air temperature (IAT) sensor (2) electrical connector.




4. Remove the IAT sensor from the center intake manifold.

Installation Procedure






Notice: Refer to Fastener Notice.

1. Install the IAT sensor to the center intake manifold.

Tighten the IAT to 25 N.m (18 lb ft).

2. Connect the IAT sensor (2) electrical connector.
3. Install the air intake pipe.
4. Connect the negative battery cable.