B2610

DTC B2610

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B2610 00
- Passenger Compartment Dimming 1 Circuit

Diagnostic Fault Information






Circuit/System Description

The body control module (BCM) supplies a voltage reference through the instrument panel (I/P) dimming voltage reference circuit to the interior lamp dimmer switch, which is part of the headlamp switch. When the dimmer switch is placed in a desired brightness position, reference voltage is applied through the dimmer switch rheostat and the I/P lamps dimmer switch signal circuit to the BCM. The BCM interprets this voltage signal, then applies a pulse width modulated (PWM) voltage through the LED dimming supply circuit illuminating the components listed below:

* Radio
* Driver information center (DIC) switch
* Steering wheel controls

Conditions for Running the DTC

* The ignition is ON.
* The headlamps or park lamps ON.

Conditions for Setting the DTC

The BCM detects a short to ground on the LED dimming supply circuit.

Action Taken When the DTC Sets

The BCM does not attempt to illuminate the LED lamps.

Conditions for Clearing the DTC

* The condition for setting the DTC is no longer present.
* A history DTC clears after 100 malfunction-free ignition cycles.

Circuit/System Verification

Ignition ON, cover the ambient light sensor, adjust the interior lamp dimming switch from dim to full bright. The LED lamps should dim and then become full bright.

Circuit/System Testing

1. Ignition OFF, disconnect all of the LED dimming components on the LED dimming supply circuit.
2. Ignition ON, with a scan tool clear the DTC.
3. Operate the vehicle within the conditions for running the DTC and verify the DTC does not reset.

• If the DTC resets, test the LED dimming supply circuit for a short to ground. If the circuit test normal, replace the BCM.

4. Reconnect each component one at a time and verify that the DTC does not reset as current.

• If the DTC resets as current, test or replace the component responsible for setting the DTC.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

* Steering Wheel Replacement
* Inside Rearview Mirror Replacement