Wiper Motor Cover Replacement

Wiper Motor Cover Replacement

Removal Procedure




1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Disconnect the electrical connector from the wiper motor.




4. Remove the 3 screws (2) and the wiper motor cover (3) from the wiper motor (1).
5. Remove the wiper motor cover (3).

Installation Procedure






Notice: Refer to Fastener Notice.

1. Install the wiper motor cover onto the wiper motor with the 3 screws.

Tighten the screws to 3 N.m (26 lb in).




2. Connect the electrical connector to the wiper motor.
3. Install the air inlet grille panel.
4. Install the wiper arms.
5. Operate the wipers and inspect for proper operation.