OnStar Microphone Inoperative - Caller Cannot Be Heard

OnStar Microphone Inoperative - Caller Cannot Be Heard

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Diagnostic Fault Information






Circuit/System Description

The communication interface module (CIM) provides the cellular microphone with a supplied voltage on the cellular microphone signal circuit. When the microphone is in use, voice data from the user is sent back to the CIM on the signal circuit. The CIM provides a ground for the microphone via the drain wire.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the cellular microphone.
2. Ignition OFF, disconnect the harness connector at the inside rearview mirror.
3. Ignition ON, test for 9.5-10.5 volts between the signal circuit terminal B and ground.

• If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the CIM.

• If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the CIM.

4. Test for test for 9.5-10.5 volts between the signal circuit terminal B and the drain circuit terminal A.

• If less than the specified range, test the drain circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the CIM.

5. If all circuits test normal, replace the cellular microphone.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

* Mobile Telephone Microphone Replacement