Volt Gage Inaccurate or Inoperative

Volt Gage Inaccurate or Inoperative

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

The instrument panel cluster (IPC) displays the vehicle voltage based on the information from the body control module (BCM). The BCM provides voltage information to the IPC via serial data.

Diagnostic Aids

The voltmeter may fluctuate between 12 and 14 volts. This is normal operation. For further information, refer to Charging System Description and Operation or refer to Voltmeter Gage under the Instrument Panel section in the owners manual.

Circuit/System Verification

Ignition ON, perform the volt gage sweep test with the scan tool. Verify that the volt gage sweeps from its low to high position.

If the volt coolant gage does not sweep from its low to high position, replace the IPC.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests