C0245

DTC C0245

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.



DTC Descriptor
DTC C0245 00
- Wheel Speed Sensor Frequency Error

DTC C0245 5A
- Wheel Speed Sensor Plausibility Failure




Diagnostic Fault Information






Circuit/System Description

The wheel speed sensor receives a 12-volt power supply voltage from the electronic brake control module (EBCM) and provides an output signal to the EBCM. As the wheel spins, the wheel speed sensor sends the EBCM a DC square wave signal. The EBCM uses the frequency of the square wave signal to calculate the wheel speed.


Conditions for Running the DTC

* The ignition is ON.
* Ignition voltage is greater than 9.5 volts.
* No wheel speed sensor faults exist.
* Brake is not applied.
* Vehicle is not cornering.
* No wheel spinning is detected.



Conditions for Setting the DTC

Wheel speed differences between one wheel and the others is greater than 25 percent.


Action Taken When the DTC Sets

* Antilock Brake System (ABS), Traction Control System (TCS) and Vehicle Stability Enhancement System (VSES) are disabled for the remainder of the ignition cycle.
* The ABS and Stabilitrak indicator turns ON.
* The service Traction Control and Stabilitrak displays on the DIC.



Conditions for Clearing the DTC

* The DTC becomes history when the conditions for setting the DTC are no longer present.
* The history DTC clears after 100 malfunction-free ignition cycles.
* The EBCM receives a clear code command from the scan tool.



Diagnostic Aids

* Faulty wheel speed sensor will not set this DTC.
* A vehicle using a space saver spare will not set this code.



Reference Information
Schematic Reference

Antilock Brake System Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views
Description and Operation

ABS Description and Operation (With JL4) (ABS Description and Operation (With RPO JL4))ABS Description and Operation (Without JL4) (ABS Description and Operation (Without RPO JL4))
Electrical Information Reference

* Circuit Testing
* Connector Repairs
* Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs

Scan Tool Reference

Control Module References for Scan Tool Information


Circuit/System Verification

Inspect for one tire that has improper air pressure or improper size.


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.