Transmission Control Replacement

Transmission Control Replacement

Removal Procedure

Important:
* Ensure that the control lever is positioned into the mechanical third or fourth gear prior to removal of the shift lever from the transmission. The transmission must remain in this state when the shift lever is removed.

* Do not disassemble the transmission shift lever. Internal parts for this shift lever are not available. Opening the shift lever voids the warranty.

* When removing the shift lever from the transmission, use the exposed bolts on the base of the lever.








1. Remove the control lever and boot. Refer to Transmission Control Lever Boot Replacement (Transmission Control Lever Boot Replacement) .
2. Remove the boot.
3. Remove the shift lever bolts.
4. Remove the shift lever and seal.
5. Remove the shift lever insulator.



Installation Procedure





1. Install a NEW shift lever insulator.
2. Install the shift lever seal and lever.
Notice: Refer to Fastener Notice .


3. Install the shift lever bolts.

Tighten the bolts to 20 N.m (15 lb ft).

4. Install the boot.
5. Install the control lever and boot. Refer to Transmission Control Lever Boot Replacement (Transmission Control Lever Boot Replacement) .