P16F2

DTC P16F2

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P16F2
- Control Module Direction Range Switch

Circuit/System Description

This diagnostic applies to internal microprocessor integrity conditions within the hybrid powertrain control module (HPCM). The HPCM monitors its ability to read and write to the memory. The HPCM processor monitors the data to verify that the indicated direction range switch calculation is correct.

Conditions for Running the DTC

* The control module runs the program to detect an internal fault when the key is ON.
* Ignition voltage is 8-18 volts.

Conditions for Setting the DTC

The control module has detected an internal malfunction.

Action Taken When the DTC Sets

* DTC P16F2 is a Type A DTC.
* The HPCM commands the battery energy control module (BECM) to open the high voltage contactor relays.

Conditions for Clearing the DTC

DTC P16F2 is a Type A DTC.

Circuit/System Verification

1. Clear the DTC information.
2. Turn the ignition OFF for 1 minute.
3. Turn the ignition ON.
4. Retest for DTC P16F2.

Circuit/System Testing

Program the PIM with the latest software version and recheck for DTCs.

If the DTC resets, replace the Drive Motor Generator Power Inverter Module Assembly (PIM).

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests