Video Entertainment System Inoperative

Video Entertainment System Inoperative

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Testing

Important: If rear video display turns ON but the video is blank, use diagnostic Video Display is Poor or Blank.

1. Disconnect the second row video (and third row if equipped) display harness connector. With the ignition ON, operate the rear entertainment system. Verify there is voltage on the remote enable signal circuit.

• If voltage is not present on the remote enable signal circuit, test and repair open or short to ground.
• If the enable signal circuit tests normal but there is no voltage, replace the radio.

2. Test and repair open, short to ground and short to power on the ground and battery positive voltage circuits at the second row video (and third row if equipped) display.

• If the video display power and ground circuits test normal, replace the suspected rear video display.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Video Display Replacement (Second Row) Video Display Replacement (Third Row)