C0558
DTC C0558
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
DTC Descriptor
DTC C0558 4B
- Calibration Data Not Programmed
Circuit/System Description
The rear differential clutch control module (CCM) is required to have the correct calibration data (matching ID) stored in the memory from the AWD coupling control, and is part of the programming used to perform all wheel drive functions.
Conditions for Running the DTC
Ignition voltage is greater than 9 volts.
Conditions for Setting the DTC
The calibration data (matching ID) of the CCM is not programmed or incorrectly programmed.
Action Taken When the DTC Sets
One or more of the following actions may occur:
* All Wheel Drive Off (AWD Disabled), DIC message
* Service All Wheel Drive (Service AWD), DIC message
Conditions for Clearing the DTC
* The condition for the DTC is no longer present.
* The DTC is not detected in 40 consecutive drive cycles.
Reference Information
Schematic Reference
All-Wheel Drive Schematics (Electrical Diagrams)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
All-Wheel Drive Description and Operation (All-Wheel Drive Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Verification
Verify that DTC C0558 is not set.
If the DTC is set, calibrate the CCM. If the DTC resets, replace the CCM.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Control Module References (Programming and Relearning) for CCM replacement, setup, and programming