101. Engine Prelubing

Engine Prelubing

Special Tools

J 45299 - Engine Preluber

For equivalent regional tools, refer to Special Tools (Special Tools).





Note: A constant/continuous flow of clean engine oil is required to properly prime the engine.

Caution: Refer to Fastener Caution (Fastener Caution).

1. Remove the engine oil filter, fill with clean engine oil, and reinstall. Tighten the oil filter to 30 Nm (22 lb ft).
2. Remove the engine block oil gallery plug (1).
3. Install the M16 x 1.5 adapter P/N 509375.




4. Install the flexible hose to the adapter and open the valve.
5. Pump the handle on J 45299 - preluber to flow a minimum of 1-2 quarts of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
6. Close the valve and remove the flexible hose and adapter from the engine.
7. Install the oil pressure sensor. Tighten the oil pressure sensor to 35 Nm (26 lb ft).
8. Top-off the engine oil to the proper level.