Seat Cushion Outer Trim Panel Replacement

Seat Cushion Outer Trim Panel Replacement

Removal Procedure

1. Remove the trim panel from the power seat by performing the following:

1. Remove the 3 seat switch bezel mounting screws. Refer to Driver or Passenger Seat Adjuster Switch Bezel Replacement (Driver or Passenger Seat Adjuster Switch Bezel Replacement).




2. Remove the 3 trim panel retaining screws.

2. Remove the trim panel from the manual seat by performing the following steps:

1. Remove the lumbar support knob. Refer to Lumbar Support Knob Replacement (Lumbar Support Knob Replacement).
2. Remove the seat back recliner handle. Refer to Driver or Passenger Seat Recliner Handle Replacement (Driver or Passenger Seat Recliner Handle Replacement).




3. Remove the screws from the trim panel.

3. Remove the trim panel from the seat assembly.

Installation Procedure

1. Install the trim panel to the power seat by performing the following steps:




1. Align the trim panel to the seat assembly.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the screws retaining the trim panel to the seat assembly.

Tighten the trim panel screws to 3 Nm (26 lb in).

3. Install the 3 seat switch bezel mounting screws.

Tighten the seat switch bezel mounting screws to 3 Nm (26 lb ft).

2. Install the trim panel to the manual seat by performing the following steps:




1. Install the screws in the trim panel.
2. Install the lumbar support knob. Refer to Lumbar Support Knob Replacement (Lumbar Support Knob Replacement).
3. Install the seat back recliner handle. Refer to Driver or Passenger Seat Recliner Handle Replacement (Driver or Passenger Seat Recliner Handle Replacement).