Operation CHARM: Car repair manuals for everyone.
Home >> GMC Truck >> 2009 >> Savana 2500 V8-6.0L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Timing Components >> Variable Valve Timing >> Variable Valve Timing Actuator >> Service and Repair >> Camshaft Position Actuator Magnet Replacement

Camshaft Position Actuator Magnet Replacement




Camshaft Position Actuator Magnet Replacement

Removal Procedure




1. Remove the water pump. Refer to Water Pump Replacement (LU3) (Service and Repair)Water Pump Replacement (LMF/LY2) (Service and Repair)Water Pump Replacement (LMM) (Service and Repair)Water Pump Replacement (LY6) (Service and Repair).
2. Disconnect the engine harness electrical connector from the camshaft position (CMP) actuator magnet.
3. Remove the CMP actuator magnet bolts (751) and magnet (752).
4. Remove and discard the CMP actuator magnet gasket (753).

Installation Procedure

Note: The gasket surface should be free of oil or other foreign material during assembly.




1. Install a NEW CMP actuator magnet gasket (753) onto the CMP actuator magnet.
2. Install the CMP actuator magnet (752) to the front cover.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the CMP actuator magnet bolts (751) and tighten to 12 Nm (106 lb in).
4. Connect the engine harness electrical connector to the CMP actuator magnet.
5. Install the water pump. Refer to Water Pump Replacement (LU3) (Service and Repair)Water Pump Replacement (LMF/LY2) (Service and Repair)Water Pump Replacement (LMM) (Service and Repair)Water Pump Replacement (LY6) (Service and Repair).

pro multis · About Operation CHARM