Power Steering Cooler Pipe/Hose Replacement (GT5)

Power Steering Cooler Pipe/Hose Replacement (GT5)

Removal Procedure





Caution: Refer to Power Steering Hose Disconnected Caution (Service Precautions).

1. Install drain pan under the vehicle.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
3. Disconnect the power steering cooler hose from the power steering pump.
4. Disconnect the power steering cooler hose from the power steering gear.
5. Cap the power steering pipes and cooler ends in order to prevent the entry of dirt.
6. Remove the power steering cooler mounting nuts.
7. Remove the power steering cooler from the vehicle.

Installation Procedure




1. Install the power steering cooler to the vehicle.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the power steering cooler mounting nuts and tighten to 28 Nm (21 lb ft).
3. Connect the power steering cooler hose to the power steering gear and tighten to 33 Nm (24 lb ft).
4. Connect the power steering cooler hose to the power steering pump.
5. Lower the vehicle.
6. Bleed the power steering system. Refer to Power Steering System Bleeding (Service and Repair).
7. Remove the drain pan from under the vehicle.