Intake Manifold Replacement - Right SIDE

Intake Manifold Replacement - Right Side

Removal Procedure





1. Remove the center intake manifold. Refer to Center Intake Manifold Replacement (Service and Repair) .
2. Remove the right fuel rail. Refer to Fuel Injection Fuel Feed Front Pipe Replacement - Right Side (Service and Repair) .
3. Remove the intake manifold bolts/nuts.
4. Remove the fuel return junction block. Refer to Fuel Injection Fuel Feed Manifold Replacement (Service and Repair) .


Note

The intake manifold uses sealer. Pry at the area by the fuel rail bolt holes in order to avoid damage to the sealing surfaces.

5. Remove the intake manifold.
6. To prevent entry of debris in the cylinder head tape the openings.
7. If required, clean and inspect the intake manifold. Refer to Intake Manifold Cleaning and Inspection (Overhaul) .



Installation Procedure





1. Apply a 2-3 mm (1/8 in) wide, by 0.5-1.5 mm (1/16 in) high bead of sealant to the intake manifold. Refer to Adhesives, Fluids, Lubricants, and Sealers (Specifications) for the correct part number.




2. Install the intake manifold.
3. Install the intake manifold bolts/nuts.

Right Side:

Caution: Refer to Fastener Caution (Fastener Caution) .
4. Tighten the intake manifold bolts/nuts in the sequence shown.

Tighten the bolts/nuts to 21 Nm (15 lb ft).

5. Install the fuel return junction block. Refer to Fuel Injection Fuel Feed Manifold Replacement (Service and Repair) .
6. Install the right fuel rail. Refer to Fuel Injection Fuel Feed Front Pipe Replacement - Right Side (Service and Repair) .
7. Install the center intake manifold. Refer to Center Intake Manifold Replacement (Service and Repair) .