Starter Solenoid Cable Replacement

Starter Solenoid Cable Replacement (With L9H and TP2)

Removal Procedure





1. Disconnect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) (Service and Repair)Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) (Service and Repair)Battery Negative Cable Disconnection and Connection (With Dual Batteries) (Service and Repair) .
2. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement (Service and Repair) .
3. Remove the mega fuse cover (3).




4. Open the starter solenoid cable cover at the positive battery terminal.
5. Loosen the starter solenoid cable nut (5).
6. Remove the starter solenoid cable from the positive battery terminal.
7. Remove the starter solenoid cable clip (4) from the air conditioning (A/C) evaporator tube.




8. Remove the starter solenoid cable nut (1) from the mega fuse stud.
9. Remove the starter solenoid cable terminal (2) from the mega fuse stud.




10. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
11. Remove the front 2 oil pan skid plate bolts, loosen the rear 2 bolts and remove the skid plate.




12. Remove the starter solenoid cable clip (1) from the wheelhouse panel.
13. Remove the starter solenoid cable clip bolt (2) from the frame.




14. Remove the starter solenoid cable nut (1) from the starter.
15. Remove the starter solenoid cable (2) from the starter.
16. Lower the vehicle.




17. Remove the starter solenoid cable from the vehicle.



Installation Procedure





1. Install the starter solenoid cable to the vehicle.




2. Install the starter solenoid cable to the positive battery terminal.
Caution: Refer to Fastener Caution (Fastener Caution) .
3. Tighten the starter solenoid cable nut (5) to 5 Nm (44 lb in) .
4. Close the starter solenoid cable cover at the positive battery terminal.
5. Install the starter solenoid cable clip (4) to the A/C evaporator tube.




6. Install the starter solenoid cable terminal (2) to the mega fuse stud.
7. Install the starter solenoid cable nut (1) to the mega fuse stud and tighten to 9 Nm (80 lb in) .




8. Install the mega fuse cover (3).
9. Raise the vehicle.




10. Install the starter solenoid cable (2) to the starter.
11. Install the starter solenoid cable nut (1) to the starter and tighten to 9 Nm (80 lb in) .




12. Position the starter solenoid cable clip to the frame and install the starter solenoid cable clip bolt (2).
13. Install the starter solenoid cable clip (1) to the wheelhouse panel.




14. Install the oil pan skid plate and tighten the rear 2 bolts and install and tighten the front 2 bolts and tighten to 28 Nm (21 lb ft) .
15. Lower the vehicle.
16. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement (Service and Repair) .
17. Connect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) (Service and Repair)Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) (Service and Repair)Battery Negative Cable Disconnection and Connection (With Dual Batteries) (Service and Repair) .