Fuel Pressure Control Module: Service and Repair

Fuel Pump Flow Control Module Replacement

Removal Procedure




1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Disengage the fuel pump flow control module cover retainers (2) from the frame.
3. Remove the fuel pump flow control module cover (1).




4. Disconnect the chassis wiring harness electrical connector (1) from the fuel pump flow control module.




5. Loosen the fuel pump flow control module bolts (1).
6. Slide the fuel pump flow control module (2) towards the passenger side of the vehicle.
7. Remove the fuel pump flow control module from the vehicle.

Installation Procedure




1. Position the fuel pump flow control module (2) to the vehicle.
2. Slide the fuel pump flow control module towards the driver side of the vehicle.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Tighten the fuel pump flow control module bolts (1).

Tighten the bolts to 9 Nm(80 lb in).




4. Connect the chassis wiring harness electrical connector (1) to the fuel pump flow control module.




5. Position the fuel pump flow control module cover (1) over the module.
6. Install the fuel pump flow control module cover retainers (2) to the frame.
7. Lower the vehicle.
8. Program the fuel pump flow control module. Refer to Control Module References (Programming and Relearning).