Electronic Suspension Control Module Programming and Setup

Electronic Suspension Control Module Programming and Setup (Without Z95)

Electronic Suspension Control Module (ESCM) Replacement/Reprogramming

If the electronic suspension control module (ESCM) is replaced, the following procedures must be performed:

1. ESCM programming-Refer to Service Programming System (SPS) (Programming and Relearning).
2. Revise the trim set calibration using the scan tool ALC Trimset Special Function. Refer to Suspension Position Calibration (Without Z95) (Programming and Relearning)Suspension Position Calibration (With Z95) (Programming and Relearning).