Electronic Brake Control Module: Service and Repair

Electronic Brake Control Module Replacement

Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning (Brake Fluid Irritant Warning).


Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution (Brake Fluid Effects on Paint and Electrical Components Caution).

1. Turn the ignition switch to the OFF position.
2. Remove the brake pressure modulator valve (BPMV). Refer to Brake Pressure Modulator Valve Replacement (Service and Repair).




3. Remove the electronic brake control module (EBCM) bolts (1).
Discard the bolts.




4. Carefully separate the EBCM (1) from the BPMV.
5. Remove the 12 EBCM to BPMV seals (2).

Installation Procedure




1. Carefully install the EBCM (1) and the 12 seals (2) to the BPMV.





Caution: Refer to Fastener Caution (Fastener Caution).

Note: Do not reuse the EBCM bolts. Install new bolts.

2. Install new EBCM bolts (1) and tighten to 2 Nm (18 lb in).
3. Install the EBCM/BPMV assembly to the vehicle. Refer to Brake Pressure Modulator Valve Replacement (Service and Repair).
4. Program the EBCM. Refer to Control Module References (Programming and Relearning).