Wheel Drive Shaft Replacement

Wheel Drive Shaft Replacement (1500)

Warning

Do not attempt to move vehicle with drive axle(s) removed from wheel bearing. Wheel(s) could fall off, dropping vehicle to the ground and causing personal injury or damage to the vehicle.

Special Tools

J-45859 - Axle Remover

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
3. Remove the front axle hub cap from the wheel bearing, if equipped.




4. Insert a drift or large screwdriver through the brake caliper into one of the brake rotor vanes in order to prevent the wheel drive shaft from turning.





Note: DO NOT reuse the wheel drive shaft nut, use a NEW nut only.

5. Remove the nut (1) and washer (2) from the hub.




6. Using the J-45859 - Axle Remover , remove the wheel drive shaft from the hub.




7. Remove the retaining bolts from the drive flange.
8. Remove the stabilizer shaft link from the lower control arm. Refer to Stabilizer Shaft Replacement (1500) (Service and Repair)Stabilizer Shaft Replacement (2500, 3500) (Service and Repair).
9. Remove the shock module. Refer to Shock Absorber and Spring Assembly Replacement (Shock Absorber and Spring Assembly Replacement).




10. Remove the wheel drive shaft through the lower control arm opening.
11. Remove all dirt and debris from the splines on the wheel hub/bearing.

Installation Procedure




1. Install the wheel drive shaft in the steering knuckle.





Note: Install the NEW nut and washer, but DO NOT tighten at this time.

2. Install the NEW nut (1) and washer (2).




3. Install the retaining bolts and finger tighten.




4. Insert a drift or large screwdriver through the brake caliper into one of the brake rotor vanes in order to prevent the wheel drive shaft from turning.

Caution: Refer to Fastener Caution (Fastener Caution).

5. Tighten the wheel driver shaft retaining bolts and tighten to 79 Nm (58 lb ft).
6. Tighten the wheel drive shaft retaining nut and tighten to 240 Nm (177 lb ft).
7. Install the shock module. Refer to Shock Absorber and Spring Assembly Replacement (Shock Absorber and Spring Assembly Replacement).
8. Install the stabilizer shaft link from the lower control arm. Refer to Stabilizer Shaft Replacement (1500) (Service and Repair)Stabilizer Shaft Replacement (2500, 3500) (Service and Repair).
9. Install the front axle hub cap to the wheel bearing, if equipped.
10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
11. Lower the vehicle.