Ignition Lock Cylinder Case Replacement

Ignition Lock Cylinder Case Replacement

Removal Procedure

Warning: Refer to SIR Warning (SIR Warning).

1. Remove the inflatable restraint steering wheel module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement (Removal and Replacement).
2. Remove the ignition/start switch. Refer to Ignition and Start Switch Replacement (Service and Repair).
3. Disconnect the park lock cable from the ignition lock cylinder case.
4. Disconnect the passlock and key buzzer from the ignition lock cylinder case.




5. Remove the 3 ignition lock cylinder case screws (2).
6. Remove the ignition lock cylinder case (1) from the vehicle.

Installation Procedure




1. Install the ignition lock cylinder case (1) to the vehicle.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the 3 ignition lock cylinder case screws (2).

Tighten the screws to 7 Nm (62 lb in).

3. Install the park lock cable into the lock cylinder housing.
4. Connect the passlock and key buzzer to the ignition lock cylinder case.
5. Install the ignition/start switch. Refer to Ignition and Start Switch Replacement (Service and Repair).
6. Install the inflatable restraint steering wheel module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement (Removal and Replacement).