Clutch Pedal Position Sensor / Switch: Service and Repair

Clutch Pedal Engine Start Switch Replacement

Removal Procedure




1. Disconnect the clutch pedal position switch electrical connector (1).




2. Remove the plastic retainer (1) tabs from the clutch pedal position switch (2).
3. Remove the clutch pedal position switch (2) from the pushrod.

Installation Procedure




1. Install the clutch pedal position switch (2) to the pushrod.
2. Install the plastic retainer (1) tabs to the clutch pedal position switch (2).




3. Connect the clutch pedal position switch electrical connector (1).

Warning

Replacement or reprogramming of the ECM, or replacement of the clutch pedal position sensor (CPPS) or clutch pedal requires that a CPPS learn procedure be performed. Failure to perform the CPPS learn procedure may result in personal injury or damage to the vehicle or its components if the vehicle is in gear and the starter motor is accidentally engaged.

4. Perform the clutch pedal position sensor learn procedure. Refer to DTC P080A (Tremec 5-Speed (TZ0) - Manual Transmission) or Clutch Pedal Position Sensor Learn (Component Tests and General Diagnostics).