Front Drive Axle Actuator Replacement

Front Drive Axle Actuator Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the front differential carrier shield, if equipped. Refer to Shield Replacement (Service and Repair).
3. Disconnect the electrical connector from the actuator.




4. Remove the actuator (1) for the 8.25 inch axle (2) or (3) for the 9.5 inch axle (4) by turning the actuator counterclockwise.

Installation Procedure




1. Apply sealant to the threads of the actuator (1) for the 8.25 inch axle (2) or (3) for the 9.25 inch axle (4). Use the correct sealant. Refer to Adhesives, Fluids, Lubricants, and Sealers (Front Drive Axle).

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the actuator (1 or 3) and tighten to 20 Nm (15 lb ft)..
3. Connect the electrical connector to the actuator.
4. Install the front differential carrier shield, if equipped. Refer to Shield Replacement (Service and Repair).
5. Lower the vehicle.