Ignition Lock Cylinder Case Replacement

Ignition Lock Cylinder Case Replacement

Removal Procedure

1. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (Ignition Lock Cylinder Replacement).
2. Remove the multifunction turn signal switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement (Multifunction Turn Signal Switch Housing Replacement).
3. Disconnect any electrical connectors as necessary.




4. Use any of the following common tools in order to remove the shear bolt from the ignition lock cylinder case:

* An angle grinder and a screwdriver
* A hammer and a chisel
* A screw extractor
* A center punch

5. Discard the old bolt.
6. Remove the ignition lock cylinder case.

Installation Procedure




1. Position the ignition lock cylinder case on the steering column.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the NEW ignition lock cylinder case bolt and tighten until the head shears off.
3. Install the multifunction turn signal switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement (Multifunction Turn Signal Switch Housing Replacement).
4. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (Ignition Lock Cylinder Replacement).
5. Connect any electrical connectors as necessary.

Note: For vehicles with RPO BAE, programming is not necessary.

6. For vehicles without RPO BAE, the passlock sensor is part of the ignition and start switch and requires a relearn procedure. Refer to Immobilizer System Component Programming (without BAE) (Immobilizer System Component Programming (without BAE))Immobilizer System Component Programming (with BAE) (Immobilizer System Component Programming (with BAE)).