Power Brake Booster Outlet Hose Replacement

Power Brake Booster Outlet Hose Replacement

Removal Procedure

1. Place drain pans under the vehicle.
2. Siphon the power steering fluid from the reservoir.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).





Caution: Refer to Power Steering Hose Disconnected Caution (Service Precautions).

4. Through the wheel well, disconnect the power brake booster outlet hose (1) from the steering gear (2).
5. If necessary, remove the water deflector from the fender.




6. Remove the power brake booster outlet hose (1) from the power brake booster (2).
7. Remove the power brake booster outlet hose from the vehicle.

Installation Procedure

Caution: Refer to Installing Hoses without Twists or Bends Caution (Installing Hoses Without Twists or Bends Caution).

1. Position the power brake booster outlet hose in the vehicle.

Caution: Refer to Fastener Caution (Fastener Caution).




2. Install the power brake booster outlet hose (1) to the power brake booster (2). Hand tighten the fitting.




3. Through the wheel well, connect the power brake booster outlet hose (1) to the steering gear (2) and tighten to 33 Nm (24 lb ft).
4. Lower the vehicle.
5. Tighten the power brake booster outlet hose fitting at the power brake booster to 34 Nm (25 lb ft).
6. If you removed the water deflector, install the water deflector to the fender.
7. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (Service and Repair).
8. Remove the drain pans.