116. Fuel Injector Installation

Fuel Injector Installation




1. Install a NEW O-ring seal (3) onto the fuel injector.
2. Lubricate the O-ring seal with engine oil.
3. Install a NEW copper washer to the fuel injector.
4. Install the fuel injector bracket pin (2).

Note: The unique fuel injector flow rates are programmed into the ECM according to cylinder location. Mark the fuel injectors for correct re-installation to the same cylinders. Failure to do so may result in a poor drive-ability condition.

5. Install the fuel injector with fuel injector bracket (1).





Caution: Refer to Fastener Caution (Fastener Caution).

6. Install the fuel injector bracket bolt (1) and tighten to 30 Nm (22 lb ft).
7. Repeat steps 1-6 to install the remaining injectors.