Operation CHARM: Car repair manuals for everyone.
Home >> GMC Truck >> 2011 >> Sierra 2500 Denali 4WD V8-6.6L DSL Turbo >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Service and Repair >> Overhaul >> Allison - Automatic Transmission >> 80. Output Shaft Bushing Replacement

80. Output Shaft Bushing Replacement




Output Shaft Bushing Replacement

Tools Required
* J 43791 Output/Turbine Shaft Bushing Installer
* J 44526 Output/Turbine Shaft Bushing Remover

Removal Procedure




1. Install J 44526-2 bolt (8) and J 44526-1 extractor (7) into the bushing (9).
2. Install J 44526-2 bolt (8) into J 44526-1 extractor (7).
3. Install the washer (6) and nut (5) onto J 44526-2 bolt (8).
4. Hold the top of J 44526-2 bolt (8) with a wrench and tighten the nut (5) until J 44526-1 extractor (7) engages the bushing (9).
5. Install the bearing (3), washer (2), and nut (1) onto J 44526-2 bolt (8).
6. Install J 44526-3 protector (4) onto J 44526-2 bolt (8).
7. Hold the top of J 44526-2 bolt (8) with a wrench and tighten the nut (1) until the bushing is dislodged.
8. Remove the J tools.
9. Remove the bushing from J 44526 .

Installation Procedure




1. Install a new output shaft bushing (2) onto J 43791 (1).
2. Using J 43791 , drive the bushing into the output shaft (3) until J 43791 (1) is seated to specification.

Make sure the bushing is pressed flush to 0.25 mm (0.01 in) below the output shaft surface.

pro multis · About Operation CHARM