36. Oil Pump Installation

Oil Pump Installation




1. Install a new O-ring to the engine block.
2. Lubricate the O-ring with engine oil.
3. Install the oil pump.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the oil pump bolts and tighten to 21 Nm (15 lb ft).





Note: Do not damage the crankshaft sensor reluctor teeth.

5. Install the oil pump drive gear and crank sensor reluctor assembly.




6. Install the oil pump driven gear.





Caution: Do not use an impact driver to remove or install the oil pump driven gear nut. Use of an impact driver may shear the oil pump drive gear pin in the crankshaft.

Note: Look for an "L" on the end of the oil pump shaft. If there is an "L" present, the nut and shaft have left hand threads. Service the nut accordingly.

7. While holding the secondary oil pump shaft with a hex driver, install the oil pump driven gear nut. Tighten the oil pump driven gear nut to 100 Nm (74 lb ft).