Front Axle Vent Hose Connector Replacement

Front Axle Vent Hose Connector Replacement

Removal Procedure




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the engine shield, if equipped. Refer to Engine Shield Replacement (Engine Shield Replacement).
3. Remove the vent hose (1).
4. Remove the vent hose connector (2).

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the vent hose connector (2). Apply a small amount of sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the threads.

Tighten the vent connector to 20 Nm (15 lb ft).

2. Install the vent hose (1).
3. Install the engine shield, if equipped. Refer to Engine Shield Replacement (Engine Shield Replacement).
4. Lower the vehicle.