Operation CHARM: Car repair manuals for everyone.

C0394




DTC C0394

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptors
DTC C0394 02
- Rear Differential Clutch Temperature Sensor Circuit Short to Ground

DTC C0394 04
- Rear Differential Clutch Temperature Sensor Circuit Open

Diagnostic Fault Information





Circuit/System Description

The rear differential clutch control module provides a power and ground circuits to the temperature sensor. When the temperature of the module is determined to be beyond its limits, the rear differential clutch control module will temporarily disable the rear drive system.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

An open or short to ground is detected on the temperature sensor circuits.

Action Taken When the DTC Sets

One or more of the following actions may occur:

* All Wheel Drive Off (AWD Disabled).
* Service All Wheel Drive (Service AWD).

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.
* The DTC is not detected in 40 consecutive drive cycles.

Reference Information
Schematic Reference

Rear Axle Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Rear Drive Axle Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the X2 harness connector at the rear differential clutch control module.
2. Ignition ON, verify a test lamp does not illuminate between the following circuits and ground:

* low reference terminal 2
* signal terminal 4

If the test lamp illuminates, test the appropriate circuit for a short to voltage.

3. Ignition OFF, test for infinite resistance between the following circuit terminals and ground:

* low reference terminal 2
* signal terminal 4

If less than the specified value, test the appropriate circuit for a short to ground.

4. Test for 310-113 k ohm between the low reference circuit terminal 2 and the signal circuit terminal 4.

If greater than the specified range, test the appropriate circuit for an open/high resistance. If the circuits test normal, replace the rear wheel drive clutch.

5. If all circuits test normal, replace the rear differential clutch control module.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Rear Wheel Drive Module Clutch Housing Replacement (Rear Wheel Drive Module Clutch Housing Replacement)
* Control Module References (Programming and Relearning) for rear differential clutch control module replacement, setup, and programming