Engine Support Fixture
Engine Support Fixture
Special Tools
* J 28467-B Universal Engine Support Fixture
* J 28467-501 Engine Support Fixture Adapters
* J 36857 Engine Lift Bracket
Installation Procedure
1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement (Intake Manifold Cover Replacement).
2. Remove the right headlamp. Refer to Headlamp Replacement (Equinox) (Removal and Replacement)Headlamp Replacement (Terrain) (Removal and Replacement).
3. J-36857 - engine rear lift bracket
4. J-36857 - engine front lift bracket
5. Loosen the J 28467-501 adjusting nut.
6. Assemble the J 28467-501 legs to the vehicle and install the J 28467-B cross bar and place across the engine compartment.
7. Tighten the adjusting nuts on the J 28467-501 legs until snug, then back the nut off 1/4 turn.
8. From the J 28467-B universal engine support fixture, install the radiator shelf tube J-28467-2A (1) on top of the strut tower tube J-28467-3 (2) above the engine front (right back) lift hook bracket.
9. Install the round tube of the front support assembly J-28467-4A (3) through the large hole in the radiator shelf tube J-28467-2A.
10. Locate the J-28467-4A front support assembly to the upper tie bar.
11. Install the J-28467-9 7/16 inch x 2.0 inch quick-release pin (4) through the top hole in the J-28467-4A front support assembly.
12. Install the J-28467-1A cross bracket assembly (1).
13. Hand tighten the J-28467-1A cross bracket wing nuts (2).
14. Install the J-28467-7A bolt hook through the J-28467-6A bracket.
15. Install the J-28467-34 lift hook wing nut and washer to the J-28467-7A lift hook.
16. Install one of the lift hook and bracket assemblies (1) to the engine support fixture long bar (2).
17. Install the other lift hook and bracket assembly (3) to the J-28467-2A radiator shelf tube (4) above the engine front lift bracket.
18. Install the lift hook J-28467-7A through the engine rear lift bracket.
19. Install the lift hook J-28467-7A (3) through the engine front lift bracket.
20. Hand tighten the lift hook wing nuts J-28467-34 in order to remove all slack from the engine support fixture assembly.