Cruise Control Switch Indicator Inoperative

Cruise Control Switch Indicator Inoperative

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Diagnostic Fault Information






Circuit/System Description

The body control module (BCM) monitors the cruise control indicator switch. When the cruise on/off switch is pressed ON, the cruise control switch is closed and the signal circuit is low. When the cruise on/off switch is pressed OFF, the cruise control switch is open and the signal circuit is high.

Reference Information

Schematic Reference

Cruise Control Schematics Electrical Diagrams

Connector End View Reference

Component Connector End Views A/C Compressor Clutch

Description and Operation

Cruise Control Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearning for scan tool information

Circuit/System Testing

Important:
Refer to DTC B3794 B3794 before performing this diagnostic, if this code is set as current or history.


1. Ignition OFF, disconnect the harness connector at the steering wheel controls switch-left.

2. Ignition ON, verify that a test lamp illuminates between the low reference circuit terminal 9 and B+.

• If the test lamp does not illuminate, test the low reference circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.

3. If all circuits test normal, test or replace the steering wheel controls switch-left.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Steering Wheel Control Switch Assembly Replacement (Traverse) Service and RepairSteering Wheel Control Switch Assembly Replacement (Acadia/Enclave) Service and Repair

* Control Module References Programming and Relearning for BCM replacement, setup, and programming