132. Crankshaft Balancer Installation

Crankshaft Balancer Installation

Special Tools

* EN-46106 - Engine Flywheel Holding Tool

* J-41998-B - Crankshaft Balancer Installer

* J-45059 - Angle Meter
For equivalent regional tools, refer to Special Tools Special Tools.




1. The EN-46106 - tool must be installed onto the flywheel.

2. Use the J-41998-B - installer, nut, bearing and washer to install the crankshaft balancer.





Note: Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.

3. Apply lubricant to the inside of the crankshaft balancer hub bore.




4. Place the crankshaft balancer in position on the crankshaft.

5. Thread the J-41998-B - installer in the crankshaft. Ensure you engage at least 10 threads of the J-41998-B - installer before pressing the crankshaft balancer in place.

6. Push the crankshaft balancer into position by tightening the nut on the J-41998-B - installer until the large washer bottoms out on the crankshaft end.

7. Remove the J-41998-B - installer.




8. Install the NEW crankshaft balancer bolt.

Caution: Refer to Fastener Caution Fastener Caution.

Caution: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

9. Tighten the crankshaft balancer bolt to 100 Nm (74 lb ft) and an additional 150 degrees using the J-45059 - meter.




10. Remove the EN-46106 - tool.