C0201

DTC C0201

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor
DTC C0201 00
- Antilock Brake System (ABS) Enable Relay Contact Circuit Open

Circuit/System Description

The solenoid relay, located within the electronic brake control module (EBCM), supplies battery voltage to all of the valve solenoids.

Conditions for Running the DTC

* Ignition voltage is greater than 9.5 V.
* The solenoid relay is commanded ON.

Conditions for Setting the DTC

The EBCM detects no change in voltage when commanding the solenoid valves ON.

Action Taken When the DTC Sets

* The EBCM disables the ABS for the duration of the ignition cycle.
* A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for setting the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 50 consecutive drive cycles.

Reference Information
Schematic Reference

Antilock Brake System Schematics [1][2]Antilock Brakes / Traction Control Systems
Connector End View Reference

Component Connector End Views Connector End Views By Name
Description and Operation Reference

ABS Description and Operation Description and Operation
Electrical Information Reference

* Circuit Testing Circuit Testing
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs
* Connector Repairs Connector Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

Ignition ON, verify that DTC C0201 is not set.

If DTC is set, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for EBCM replacement, setup, and programming