Operation CHARM: Car repair manuals for everyone.

C0240




DTC C0240

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors
DTC C0240
- ECM Traction Control Not Allowed

Circuit/System Description

The engine control module (ECM) and the electronic brake control module (EBCM) communicate on the serial data link, whenever the ignition is ON.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC

The EBCM receives a serial data message stating that the ECM has lost the ability to reduce engine torque.

Action Taken When the DTC Sets

* The EBCM disables the traction control system (TCS) and vehicle stability enhancement system (VSES).
* A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 50 consecutive drive cycles.

Reference Information
Schematic Reference

Antilock Brake System Schematics [1][2]Antilock Brakes / Traction Control Systems
Connector End View Reference

Component Connector End Views Connector End Views By Name
Description and Operation

ABS Description and Operation Description and Operation
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the EBCM.
2. Ignition ON, test for 4.8-5.2 V between the signal circuit terminal 14 and ground.

If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.

If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.

3. If the circuits test normal, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for EBCM or ECM replacement, setup, and programming