C0287
DTC C0287
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptors
DTC C0287 00
- Longitudinal Accelerometer Sensor Circuit
Circuit/System Description
The longitudinal accelerometer and the yaw rate sensors are combined into one sensor external to the electronic brake control module (EBCM). The vehicle stability enhancement system (VSES) uses the longitudinal accelerometer input when calculating the desired yaw rate. The usable output signal is a serial data CAN circuits.
Conditions for Running the DTC
The ignition switch is in the ON position.
Conditions for Setting the DTC
* The yaw/longitudinal combination sensor reports an internal failure.
* If a calculated offset at the yaw/longitudinal combination sensor signal is out of the specified range.
Action Taken When the DTC Sets
One or more of the following actions may occur:
* VSES are disabled.
* A DIC message and/or a warning indicator may be displayed.
Conditions for Clearing the DTC
* The condition for the DTC is no longer present.
* The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.
Diagnostic Aids
Possible causes of this DTC are as follows:
* Incorrectly mounted/loose yaw/longitudinal sensor
* Internal failure in the yaw/longitudinal sensor
Reference Information
Schematic Reference
Antilock Brake System Schematics [1][2]Antilock Brakes / Traction Control Systems
Connector End View Reference
Component Connector End Views Connector End Views By Name
Description and Operation Reference
ABS Description and Operation Description and Operation
Electrical Information Reference
* Circuit Testing Circuit Testing
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs
* Connector Repairs Connector Repairs
Scan Tool Reference
Control Module References Control Module References for scan tool information
Circuit/System Testing
1. Verify DTC C0186 or C0196 is not set.
• If either of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle Diagnostic Trouble Code (DTC) List - Vehicle.
2. Replace the Yaw/Longitudinal Accelerometer sensor
Repair Instructions
Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.
Vehicle Longitudinal Accelerometer Replacement Service and Repair