37. Balancer Shaft Bearing Removal

Balancer Shaft Bearing Removal

Special Tools

* J 26941 - Bushing/Bearing Remover

* J 38834 - Balance Shaft Service Kit

For equivalent regional tools, refer to Special Tools Tools and Equipment.





Warning:
Refer to Safety Glasses Warning Safety Glasses Warning.


1. Use the J 38834 - kitand the J 26941 - removerin order to remove the balance shaft rear bearing.

1. Install J 26941 - removerlegs behind the balance shaft rear bearing and secure.

2. Install the J 38834-1 with the short threaded end through the balance shaft bore in the front of the engine block.

3. Install the J 38834-1 into J 26941 - remover.

4. Slide the J 38834-2 onto the J 38834-1 and into the balance shaft bore of the engine block.

5. Install the J 38834 - kitbearing, washer, and nut onto the J 38834-1.

6. Using a wrench secure the J 38834-1 and then rotate the J 38834 - kitnut clockwise until the balance shaft rear bearing is removed from the engine block.

7. Remove the J 26941 - removerfrom the balance shaft rear bearing.

2. Discard the balance shaft rear bearing.