69. Crankshaft Balancer Installation

Crankshaft Balancer Installation

Special Tools

J 23523-F - Balancer Remover and Installer

For equivalent regional tools, refer to Special Tools Tools and Equipment.





1. Look to ensure that the crankshaft balancer front groove pin is installed in the proper location, if applicable.

The length and location of the pins must be the same as the original length and location.





Caution:
The inertial weight section of the crankshaft balancer is assembled to the hub with a rubber type material. The correct installation procedures (with the proper tool) must be followed or movement of the inertial weight section of the hub will destroy the tuning of the crankshaft balancer.

2. Apply a small amount of adhesive GM P/N 12346141 (Canadian P/N 10953433) or equivalent, onto the crankshaft balancer keyway in order to seal the crankshaft balancer keyway and crankshaft joint.

3. Align the keyway of the crankshaft balancer with the crankshaft balancer key.

4. Install the crankshaft balancer onto the end of the crankshaft.





Caution:
Refer to Fastener Caution Fastener Caution.

5. Use the J 23523-F - installerin order to press the crankshaft balancer onto the crankshaft.

1. Install the J 23523-F - installerplate and bolts onto the front of the crankshaft balancer. Tighten the J 23523-F - installerplate bolts to 25 Nm (18 lb ft).

2. Install the J 23523-F - installerscrew into the end for the crankshaft.

3. Install the J 23523-F - installerbearing, the washer, and the nut onto the J 23523-F - installerscrew.

4. Rotate the J 23523-F - installernut clockwise until the crankshaft balancer hub is completely seated against the crankshaft position sensor reluctor ring.

6. Remove the J 23523-F - installer.





7. Install the crankshaft pulley and bolts. Finger tighten all bolts until snug. Tighten the crankshaft pulley bolts to 58 Nm (43 lb ft).





8. Ensure that the crown of the crankshaft balancer washer (2) is faced away from the engine.





9. Install the crankshaft balancer washer and the bolt and tighten to 95 Nm (70 lb ft).