Operation CHARM: Car repair manuals for everyone.

Engine Front Crossmember Replacement (RWD)




Engine Front Crossmember Replacement (RWD)

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Disconnect the electrical wiring harness connectors from the engine crossmember.
3. Remove the engine crossmember mounting bolts.
4. Remove the engine crossmember.

Installation Procedure




1. Install the engine crossmember.

Caution: Refer to Fastener Caution .

2. Install the engine crossmember mounting bolts.

* LD 14,200 lb GVW, tighten the bolts to 120 Nm (89 lb ft).
* CA 14,200 lb GVW, tighten the bolts to 85 Nm (63 lb ft) plus 90 degrees.
* HD and CA, tighten the bolts to 135 Nm (100 lb ft)

3. Connect the electrical wiring harness connectors to the engine crossmember.
4. Lower the vehicle.