Steering Linkage (Non-Rack & Pinion)

Steering Linkage Inner Tie Rod Replacement

Removal Procedure

1. If you are removing the left steering linkage inner tie rod, turn the steering wheel to the right.
If you are removing the right steering linkage inner tie rod, turn the steering wheel to the left.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
3. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement Steering Linkage Outer Tie Rod Replacement.




4. Remove the steering linkage inner tie rod (1) from the relay rod.

Installation Procedure

1. Remove all traces of oil, grease, or other contaminants.
2. Clean the threads of the steering linkage inner tie rod with denatured alcohol or the equivalent and allow to dry.
3. Apply red LOCTITE(TM) Threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the steering linkage inner tie rod.





Caution: Refer to Fastener Caution Fastener Caution.

4. Install the steering linkage inner tie rod (1) to the relay rod and tighten to 110 Nm (81 lb ft).
5. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement Steering Linkage Outer Tie Rod Replacement.
6. Measure and adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment.
7. Lower the vehicle.